7
MOU TI G I STRUCTIO S
7
Vehicle body
Rubber seat
Lock nut
Flexibel
spacer
Spring seat
Spring preload
adjuster
Spring
Lower plastic
seat
6
Remove the OEM upper spring cup accord-
ing to figure.
7
Install the Öhlins spring and the spring
preload adjuster according to the figure.
8
Install the Öhlins shock absorbers on the vehi
-
cle according to the vehicle service manual.
9
Cut a 12-25 mm hole for the control wire and
adjustment knob in the side panel according
to the figure.
otee!
1
When tightening the top mount nut, the shock absorber
shaft must be held in position with a 5mm Allen key.
10
Tighten:
Lower spring seat and lock ring: 50-60 Nm
Lock nut: 30 Nm
otee!
1
Lower the vehicle so that the suspension is slightly
compressed before tightening the screws.
Cautione!
✋
Ensure that all screws are tightened to the correct
torque and that nothing fouls or restricts movement of
the shock absorber/front fork/steering damper when the
suspension is fully compressed or extended.
5 mm
20 mm
20 mm
Ø 10-15 mm
side panel
Rear seat
back rest
side panel
270 mm
Inside the trunk.
Left side.
9
6
