8
Preload adjustment
1
Put the bike on a stand and loosen
the screws in the fork top crown that
hold the fork legs.
NOTE!
On most MX-bikes you have to take
of the handle bar before you can
unscrew the top cap.
Unscrew the top cap, use a
24 mm wrench.
2
Put a box under the front wheel so
that the springs are visible.
Remove the top cap from the
damper rod extender.
Use a 16 and 24 mm wrench.
Remove the spring support.
3
Install a new preload spacer to
achieve the right static sag.
Fit
the spring support, top cap and
the handle bar.
Tighten all screws.
For tightening torques, please see
your bike's work shop manual.
1
2
3
4
5
6
