10
●電源配線
/Electric wiring
危険
/
Danger
電源への接続工事および修理は、必ずその専門の業者にお任せください。
Wiring works should be done only by qualified personnel.
漏電による感電防止のため、アース線は必ず接地してください。
D種接地工事(第
3
種接地工事)が必要です。
Ground the wire without fail for prevention of electrical shock.
D class grounding with the ground resistance of 100 ohm or less is required.
電源は必ず銘板に表示してある定格電圧を使用してください。
Ensure that the supply voltage is as specified on the rating plate.
電源取入れ口には、必ず適切なブレーカを介してください。
Electrical connection should be done via an appropriate circuit breaker.
ブレーカは必ず機器の近くに設置してください。
また、ブレーカの動作が困難になるような機器配置はしないようにしてください。
Position the circuit breaker near the MISTCATCH.
Make sure that the breaker
’s action is not interrupted by other equipment.
電源にインバータを接続して使用しないでください。
→故障の原因となります。
Do not connect an inverter to the power source.
→ Failure to this may lead to breakdown of the product.
①
M4
ねじ
4
本を緩めて電装カバーを取外してください。
Detach the cover for the electrical connection part by removing M4 screws.
These screws are retaining type.
②電源コード引き込み用キャプコンの締付キャップを緩めて電線を通してください。
(
ケーブル径φ
11
~
13)
Loosen the dome nut of the cable gland (CAPCON) to let the cable pass through.
Use cables of 11mm to 13mm diameter.
電装カバー
Cover
M4ねじ
M4 screws
MIST
CATCH
Circuit breaker
R S T
Circuit breaker
高電圧電源基板
High-voltage power board
電磁開閉器
Electromagnetic switch
電源ケーブル引き込み口キャプコン
Cable entry for power
アース端子
Ground terminal
端子台
1
Terminal board 1
端子台
2
Terminal board 2
Cable entry for alarm output signal and external operation input
警報出力信号・外部操作入力ケーブル引き込み用キャプコン