B905-FTN-TA MANUAL
Address : #181 GONG DAN-DONG, GUMI, GYEONG BUK, KOREA Page
6
/
17
TEL : 82-54-468-7063 / FAX : 82-54-461-8368
http://www.ohsungec.com/
3 - Software Requirements
3.1 – Bluetooth 5.0 LE identification
a)
Device Name: FUNCTION101 RC
b)
Vendor ID: 0x0957
c)
Product ID: 0x1000
3.2 – Pairing mode
a)
Before RCU paired or after Factory Reset, RCU works in IR.
b)
Press [OK] + [MUTE] keys for longer than 4 seconds.
c)
After 4 seconds, the LED turns ON so that to confirm the remote has entered into
pairing mode.
d)
After RCU has entered pairing mode, RCU can send the IR signal.
e)
If pairing is successfully made, the LED blinking 2 times and goes OFF. The remote
starts working in Bluetooth.
f)
If pairing is not successfully made for 60 seconds, the LED blinking 5 times quickly
and goes OFF.
3.3 - Re-pairing
a)
After RCU paired, Press [OK] + [MUTE] keys for longer than 4 seconds.
b)
After 4 seconds, RCU erases existing pairing table, and the LED turns ON so that to
confirm the remote has entered into pairing mode.
c)
After that, it is the same as in Section 3.2
3.4 – Un-pairing
a)
After RCU paired, Press [MUTE] + [STOP] keys for longer than 4 seconds.
b)
After 4 seconds, the LED blinking 2 times and goes OFF. RCU deleting the existing
pairing table and works in IR.
3.5 – Initial default set-up
