<<CLEAR>>
<<PRE SET>>
<<VOLUME SET>>
Resets the preset total
to “0000.”
Sets a preset count.
Sets a sound volume.
–
９
–
◎
LCD Panel Settings
LCD panel settings can be changed while this machine is shut down after
it has been powered on.
<Clearing the preset total indicator
→
CLEAR>
• Press the CLEAR button for about 2 seconds, and the buzzer sounds
and you can reset the preset total indicator to “0000.”
<Changing a preset count
→
PRE SET>
• A preset count can be changed by resetting the preset total indicator to
“0000.”
• Press the right-side PRE SET button to change the first digit.
Press the left-side PRE SET button to change the second digit.
• Continue pressing a PRE SET button and the buzzer sounds about 2
seconds later and, another 2 seconds later, the buzzer sounds again
with the corresponding digit in the preset count indicator blinking.
• Press the PRE SET button once momentarily while the digit is blinking
to change that digit.
• If you do not press the PRE SET button while the digit is blinking, that
digit is set. The digit is also set if you press the other PRE SET button
while the digit is blinking.
• Take out screws left at the unloading port after a setting change has
been made and return them to the Screw bin.
・
A preset count is up to 99.
A preset count is limited by the screw size snd the
capacity of the unloading port .
<Changing the sound volume
→
VOLUME SET>
• Press the VOLUME SET buttons for about 4 seconds at the same time
and the LED blinks and you can change the sound volume.
• While the LED is blinking, press the right-side button once momentarily
and the sound volume changes from medium to high, no tone, and low,
back to medium and so forth.
• If you do not operate the buttons, the LED stops blinking and the sound
volume then in effect is set.
CAUTION
