Short
Long
–
１２
–
5.7 Timer Check and Adjustment
The applied screw transfer speed varies depending on the screw type.
A longer timer interval setting is recommended for screws with a lower
transfer speed, and a shorter timer interval setting is recommended for
screws with a faster transfer speed.
• This machine is designed to halt screw transfer with a certain delay after
a certain count of screws has accumulated at the unloading port. This
delay can be adjusted with the timer.
• A Timer setting control screw is found in the rear of this machine as
shown at right.
• Turn the trimmer clockwise when this machine is viewed from the rear to
decrease the interval or counterclockwise to lengthen the interval.
• Adjust the trimmer within the range of its rotation, without using undue
force.
• Use the provided screwdriver for adjusting the trimmer.
• Set an appropriate timer interval by verifying a correct this machine
operation on applied screws.
