-
１２
-
５
-
３
．
Picking up the screw
Attach a bit to your electric screwdriver to match the head of the screw. Refer to the following.
Notice: The screwdriver bit must be magnetized before use.
Put the driver bit somewhere in the opening of the bit guide and push it
straight down while turning the bit slightly, until it hits the screw head.
Vibration of the rail shall stop when the screwdriver bit reaches the
bottom of the screw head slot.
Then pull the screw out towards yourself.
Be careful not to push the screwdriver bit into the screw head with too
much force. If the driver is lowered into the screw head with moderate
force, vibration of the rail shall stop.
Do not use more pressure than necessary to stop movement of the rail.
Standard Screw normonal
diameter
Cross size on top
No.
φ2.0
No.1/No.2
φ2.3
No.1/No.2
φ2.6
No.1/No.2
φ3.0
No.1/No.2
φ3.5
No.1/No.2
φ4.0
No.2
φ5.0
No.2
JIS
small
screw
①
②
Bit guide
Electric driver
Employed screw
Bit shape
Phillips head
Summary of Contents for NJ-2320
Page 25: ...Notes...
