OHTAKE NJ-2320, Operation Manual

Type

Model number Screw nominal

diameter

Exchange Kit

number

Rail model

number

Passage plate

model number

NJ-2320

φ2.0

R20SET

R20

W2320

NJ-2323

φ2.3

R23SET

R23

W2323

NJ-2326

φ2.6

R26SET

R26

W2326

NJ-2330

φ3.0

R30SET

R30

W2330

NJ-4535

φ3.5

R35SET

R35

NJ-4540

φ4.0

R40SET

R40

NJ-4550

φ5.0

R50SET

R50

W4550

NOTE:  Replacement rails and passage plates are available as options.

 In the Exchange Kit ordered separately, rails and passage plates are included. 

W4540

NJ-23

NJ-45

４．

Checks and Adjustments before Operation 

４

-

1

．

Confirming the machine’s Model Number

Before using this machine, verify that the model matches the screw size to be used.
To confirm the model number, note the labels attached to the rail assembly . The identification label marking is in R** form. 
This machine can be converted to different screw sizes by replacing the rail assembly, and the passage plate. When you replace 
component parts, verify the actual screw size to be used.

This machine is factory adjusted for pan-head screws prior to shipment. If readjustments are needed to match the screw 
applied, complete the following check/adjustment procedures before using this machine.

- 

４

 -

    -Checking and adjusting the brush                                      -Checking and adjusting the holding plate (screw guide 1) 
    -Checking and adjusting the passage plate                         -Checking and adjusting the rail assembly

Rail label

Rail assembly

Before performing any adjustment procedures, please turn off the power

CAUTION