- ２ -
２．
OPERATION
２
-
１．
Screw Feeding
Each time Automatic Screw Feeder picks up a screw, the count on the SET counter is decremented by one. When the
last screw of the preset count is picked up, the “COMPLETION” indicator on the counter lights up with beeps.
At the same time, the SET field shows the set count and the SET TOTAL field increments the count by one.
２
-
２．
Number adjustment
When there is a mistake in screw pick-up, and the screw is not counted, you can correct the count. Press the NO COUNT
button. The SET field and the COMPLETION indicator will flash on the LCD panel. When Automatic Screw Feeder picks
up the next screw, the SET field and the COMPLETION indicator stop flashing. With this, the count is corrected and the
normal counting resumes.
３
．
ＬＣＤ
COUNTER
See the pages below for the configuration and setting of the LCD counter.
Summary of Contents for NJ Series
Page 7: ... ６ ...
