OHTAKE NJ Series, Operation Manual

- ４ -

《

Setting a set count → PRESET

》

-You can set or change a set count when SET TOTAL is “0000”. 

Clear the SET TOTAL field. (See the next page.)

-You can set a single digit number by the RESET button (the right 

PRESET button) and a tens digit number by the CLEAR button (the left 
PRESET button).

-When you press down and hold on one of the PRESET buttons, the 

buzzer beeps in about 2 seconds; another 2 seconds later, it beeps again 

and the digit above the button will flashes on the LCD panel.

In this status, you can change (or set) a value on the digit, The value on 
the digit changes each time you click the button.

-To set the value, just wait the value stops flashing,

You can use either of the PRESET buttons to set a value on the flashing 

digit.

《

Changing the sound volume → VOLUME SET

》

-You can change the magnitude of beeping of the buzzer. Press both 

VOLUME SET buttons (NO COUNT and PRESET buttons) at the same 
time for about 4 seconds. The COMPLETION indicator flashes. Now you 

can change the volume.

-The beeping volume changes in the order below by pressing the RESET 

button while the COMPLETION indicator is flashing.

Minimum→Medium→Maximum→Mute→Minimum→Medium→….

-To set the beeping magnitude, wait untill the indicator stops flashing.

Turn on Automatic Screw Feeder and set or change counts while the screw feeder is at rest.

《ＰＲＥ

ＳＥＴ》

Set a set count.

《ＶＯＬＵＭＥ

ＳＥＴ》

Set a beeping

magnitude.

Setting on the panel before starting screw feeding