Black
BW-C1
10
Troubleshooting
State
Possible Causes
Solutions
In case of malfunctions during use, please read the manual carefully before calling for maintenance. The following table
lists the common faults, possible causes and solutions.
No Power
●
The power plug is not thoroughly
inserted into the socket
●
Please insert the power plug into the electric
socket thoroughly.
➡
➡
Not running
●
The ON/OFF button has not
been pressed down
●
Press down the TIMER button to set time and it
will start running.
➡
➡
Still running
after the set
running time
ends
●
The bed warmer switches to the
mode of cooling for 10s after the
warm air stops running
●
The device stops running after the mode of
cooling ends, and the power is cut off.
➡
➡
The bed is not
warmed up
●
Warming multiple beddings at a
time
●
Warm one bedding at a time.
➡
➡
●
The filter screen is blocked
●
Clean the the filter screen.(
→
P9)
➡
➡
●
The air inlet or air outlet is
blocked
➡
●
Please remove anything blocking the Air inlet or
air outlet.
➡
●
Keep the air entry port over 15 cm away from
wall or surrounding subjects.
➡
Error indication
of stop
●
Air inlet or nozzle ( air outlet ) is
blocked. Suction of warm air will
result in the temperature increase
of the machine inside
●
Unplug the power supply and eliminate the fault.
Wait for the internal temperature to drop before
plugging in the power supply. If not, please
contact the dealer of purchase or
Iris Ohyama
France SAS
Customer Service Center.
➡
➡
Error indication
of stop
●
Fault
●
Unplug the power supply, please contact the
dealer of purchase or
Iris Ohyama France SAS
Customer Service Center.
➡
➡