Type plate US ver. 2
Pos.
Description
Pos.
Description
9
Oil pump supply voltage, input power and
current, V / Phase / Hz / hp / A
10
Degree of protection
11
Serial number
1
Burner type:
KP = Light fuel oil
RP = Heavy fuel oil
GP = Gas
GKP = Light fuel oil and gas
GRP = Heavy fuel oil and gas
12
Month and year of manufacture
2
Overfire pressure min, IN.WC
13
Capacity, gas, MBTU/hr
3
Overfire pressure max, IN.WC
14
Capacity, light fuel oil, GPH
4
Gas calorific value, BTU/scf
15
Oil pressure, PSI
5
Gas type
16
Gas pressure min, IN.WC
6
Oil quality / viscosity
17
Gas pressure max, IN.WC
7
Control voltage, V / Phase / hp / A
18
Manufacturer address
8
Fan supply voltage, input power and
current, V / Phase / Hz / hp / A
1.4 Flue gas recirculation (optional)
The flue gas recirculation (FGR) reduces the NOx content of flue gases. A certain
proportion of flue gas is led back to the combustion chamber, which causes the flame
temperature to drop. This influences the NOx content of flue gas.
In general, the amount of recirculated flue gas must be adjusted to the smallest
possible quantity needed to obtain the required NOx rate. The flue gas quantity is
adjusted with the throttle valve located on the FGR pipe.
If the quantity of recirculated flue gas is excessive the flame may become instable and
the CO rate may increase. The amount of flue gas to circulate is set on the control
panel. To optimize the result, burner is adjusted to operate according to preset FGR-
curves.
For detailed information and instructions, see the chapters
Installation
and
Commissioning
.
M4263 2206EN
9 (102)
