● gas supply pressure
● secondary pressure
● the volume of gas to be fired
● type of gas
If the gas inlet pressure is higher than the Pmax. value given in burner’s technical
data or PI diagram, reduce the gas inlet pressure in the regulating assembly. If the
pressure regulator is not equipped with a safety relief valve and safety shut-off valve,
install these valves according to the instructions given by the manufacturer. Also any
impulse tubes must be installed according to the instructions given by the regulator
manufacturer.
If the gas inlet pressure is not stable, stabilize the pressure with the
pressure regulator.
Example of gas pressure regulating assembly
B311Z ver. 4
Pos.
Item
Pos.
Item
1
Gas pressure regulating assembly
9
Bellows compensator/gas hose
2
Ball valve
10
Safety shut-off valve, if not incl. in press.
regulator
3
Gas filter
11
Safety relief valve, if not incl. in press.
regulator
4
Pressure gauge valve
12
Blow-off, when necessary
5
Pressure gauge, high pressure
13
Pressure gauge valve, when necessary
6
Pressure regulator with safety shut-off
valve and safety relief valve
14
Pressure gauge, high pressure, when
necessary
7
Pressure gauge valve
15
Fuel flow meter, can also be on low
pressure side, when necessary
8
Pressure gauge, low pressure
16
Pressure regulator
26 (111)
M4219 2305EN
Summary of Contents for GP-600 M
