The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a
standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this
appliance.
ALPA units require a dedicated outlet with the type of receptacle as shown in the chart.
The use of extension cords is not permitted and will void the warranty.
Before connecting your equipment, check that the electrical data on the data plate match your
electrical output.
IMPORTANT NOTICE: PLUG THE EQUIPMENT INDEPENDENTLY TO A LOAD CENTER WITH AN
APPROPRIATE CIRCUIT BREAKER ACCORDING TO THE NAMEPLATE AMPS.
The shelves and holders have been fixed to the inside floor of the unit to prevent their loss during
transportation.
Insert the shelf brackets in the pilaster notches making sure they are at the same level such that the
shelves remain horizontal.
IMPORTANT: The products on each shelf must leave three to five centimeters of free clearance
The ALPA series of units are not intended to be a pull down refrigerator and as such the product
must be loaded at their intended merchandising temperature.
Before loading products, allow the equipment to operate empty for at least two hours.
When loading products:
Part Number 100330038
www.ojedausa.com | 5
ELECTRICAL REQUIREMENTS
Model
Alpa 55 120 8 15 5-15P
Alpa 36 120 6 15 5-15P
Alpa 77 120 11 20
5-20P
Alpa 99 120 16 20
5-20P
Alpa 120 120 16 20 5-20P
Voltage
(V)
Current
(A)
Circuit
Required (A)
NEMA
Config.
POSITIONING SHELVES
PRODUCT LOADING
