NEXO NLX1_LOCK INSTALLATION AND ASSEMBLY OJMAR
6
After assemblying the lock, it is needed to mount an adhesive on the front side of the door. This adhesive is needed because
the door is faceless and the user needs to know where to place the RFID card to open or close the door. There is two options,
depending if Ojmar supplies the adhesive or customer put its own adhesive:
1. Ojmar Adhesive
1.1
Clean the surface of the door and make sure that it is dry.
1.2
Fit assembly tooling on the lock as shown in next pictures taking into account the hand of the locker:
Right hand
Left hand
OK
NOK
1.3
Remove Ojmar adhesive from paper sheet
1.4
Insert the adhesive inside assembly tooling hole (R= Right hand lock, L= Left hand lock) and press the adhesive firmly so
that it is correctly attached on the door. Correct position of adhesive is shown in picture bellow.
OK
NOK
