4
10/17
1
AT-500
Illustration
Flashing red indicator stands for potentially defective battery inside.
Steady red/green indicator stands for charging/fully charged status.
Inbuilt infrared trigger is available for commentary (auto) playback.
Play/Pause
Volume down
Power on/Power off/Stop
Volume up
Charging is applicable only when the player is connected with PC via an USB cable.
Follow steps below.
1. Connect the player with your PC via an USB cable.
2. shows up on the screen.
3. Press the button and red indicator illuminates.
4. The player is being charged now. When the player is fully charged, green indicator
illuminates.
This port is connected with compatible updater for content updating.
1
1
10
9
8
7
6
5
4
3
2
Charging/battery indicator
1
Earphone jacks
7
Uploading/Charging port
6
Backlit keypad
5
2.8” TFT touch screen
4
Hi-Fi stereo and hearing-aid-compatible (HAC) speaker
3
Triggering area
2
Lanyard hole
10
Reset button
9
Wireless charging module
8
USB
1
1
Players are being wirelessly charged when they are inserted into compatible chargers.
The player will be forced to be shut down when this button is pressed.
Fast forward
Fast backward
No display
No sound
Check if battery is properly installed and powered.
T
urn on the player as instructed above.
If the problem still exists, return the player to your supplier.
Adjust the player volume to the proper level.
I
f you are using an earphone, make sure it is properly connected.
C
heck if the audio content is correctly uploaded.
If the problem still exists, return the player to your supplier.
Troubleshooting
SD error
File error
Anti-theft system alarmed
An error happens to uploaded files in the SD card. Return the player to the counter for
content re-uploading.
If the problem still exists, return the player to your supplier.
Alarm can be released via
Loop Controller LT-200+
or chargers/updaters.
Alarm will also be active when this screen shows up. Return the player to the counter
for alarm release.
To mute the player temporarily, press both and button simultaneously.
Alarm screen will remain on the screen.
An error happens to the SD card. Press the reset button and then reboot the player.
If the problem still exists, return the player to your supplier.
9
General paramters
Display
Memory capacity
Automatic triggering
Alarm
Nubmer of languges
Number of messages
Operating temperature
2.8 inch TFT-LCD (240 x 320 pixel)
8 GB, support up to 32 GB
3.7 V, 1700 mAh Li-Polymer battery
12 hours
IR
Anti-theft system
Max. 32
Max. 9999 x 32
Battery
battery life
-10 °C
~
+50 °C
23.2 x 61.5 x 135 (mm)
175 g (with battery)
Dimensions (DxWxH)
Weight
Specifications
Audio parameters
Audio format
Bandwidth
Dynamic range
Distortion
Speaker
Earphone output
20 Hz - 15 kHz
High quality audio compression
90 dB
< 0.1%
Built-in 0.5 W @ 8
Ω
3.5 mm Jack x 2 (stereo)
AT-500
Audio Guide
AT-500
Audio Guide
