OkiLAN 8300e Network User’s Guide, C6000n and C6100 Series
UNIX - 101
UNIX
Overview
The OkiLAN print server supports many protocols such as LPD, FTP,
TELNET, SNMP and IPP, and works within the UNIX environment.
To use the network card within the UNIX environment, the
following steps are required:
Configuration
Network Interface card setting
The first step in installing the network card under UNIX is to set up
the IP address, Subnet Mask and Gateway. This section explains
one way to set them up from a UNIX workstation.
>
The network addresses used in this manual are shown as
examples only. Network addresses used in your installation
must be generated for your own network.
>
Log in as [root] to change the configuration of the Print
Server. By default, there is no root password.
>
If an incorrect IP address, Subnet Mask or Gateway is
entered, the network may go down or other damage may
occur. Check the address with your network manager.
The following explanation uses Sun Solaris 2.8 (Solaris 8) as an
example. The actual commands may differ between versions of
UNIX, so refer to the workstation manuals for more information.
1. Log in as root to the workstation
If you do not have superuser rights, the network manger
should conduct the configuration.
2. If the print server does not have an IP addresses already
assigned, use the arp command to set a temporary IP
address.
Summary of Contents for 8300E C6000N
Page 1: ......
