www.okinternational.com
- 12 -
P/N 7000-1370, Revision B
B. Computer and Software Setup
System Requirements
To run the APR-5000 you will need the following:
●
PC with Pentium III processor (600 MHz or higher recommended)
●
128
MB
of
(RAM)
memory
●
3.5”
floppy
disk
drive
●
Hard disk drive with at least 20 Megabytes of free space
●
CD-ROM
●
32MB AGP video card or equivalent
●
17”
Monitor
(
.28dpi
)
●
Windows® 98, 2000 or Windows® NT operating system (The APR-5000 is
not Windows XP compatible)
Set-up
1. Unpack the computer and all its accessories.
2. Using the documentation supplied by the PC Manufacturer make all the
necessary connections and power the computer “ON”.
3. Using the supplied disks, install the APR-5000 software.
The software will automatically start the “Installshield Wizard”.
Follow all the prompts and the software will self install.
4. Connect the PC to the APR-5000 utilizing the supplied RS-232 cable.
5. Connect the video output (Figure 2. #2) to the video input on the PC utilizing the
supplied RCA video cable.
C. Final Power-up Sequence
1. Plug in the power cord on the APR-5000 Main Unit.
2. Set the APR-5000 Main power switch to the “on” position.
3. On the “desktop” Double click
the icon.
Your APR-5000 Series Rework System is now ready for operation!
IV. Software Operation
Once your system has been setup and your software has been installed you must follow
this sequence for everyday operation of your APR-5000 system.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
