Saddle stitch finisher — 86
10. Turn roller rotating knob in the direction
of the arrow.
11. Remove any misfed paper from the saddle
stitch tray. Be careful not to tear the
misfed paper during removal.
12. Close the saddle stitch section cover.
13. Close the front cover.
14. Push the saddle stitch finisher back
against the printer.
Troubleshooting (saddle stitch finisher problems)
Check the list below before calling for service.
Problem
Check
Solution or cause
Stapling position is not
correct (including
saddle stitch).
Stapling position not set properly?
Check the stapling position setting.
The saddle stitch
finisher does not
operate.
Are any saddle stitch finisher covers open?
Close all covers.
Message indicating need to remove paper from the
stapler compiler displayed?
Remove all remaining paper from the stapler
compiler.
Stapling cannot be
performed (including
saddle stitch).
Message requesting check for the staple unit
displayed?
Remove jammed staples.
Message requesting adding staples displayed?
Replace the staple cartridge
Check that a staple cartridge has been installed.
Different size paper included?
Stapling cannot be performed on to different size
paper.
Stapled sets are not
stacked correctly or
some sheets in a set are
not stapled.
Paper heavily curled?
Paper may be curled heavily depending on the paper
type and quality. Remove paper from the paper tray
or the bypass tray, turn it upside down, and load it
again.
Cannot be punched.*
Message requesting check for punch module
displayed?
Dispose of punch scraps.
* When a hole punch module is installed
Summary of Contents for B8300
