Menu functions > 18
P
RINT
MENU
This menu provides adjustment of various print job related functions.
ITEM
DEFAULT
REMARKS
COPIES
1
Enter the number of copies of a document to be
printed from 1 to 999.
DUPLEX
OFF
Switches the Duplex (2 sided) function ON/OFF.
Duplex must be fitted.
BINDING
LONG EDGE
Sets the default binding to SEF or LEF.Display
condition: duplex setting is enabled.
See
PAPER FEED
TRAY1
Selects the default tray for paper feed, Tray 1
(upper), Tray 2 (lower, if installed) or MP Tray (multi
purpose tray).
AUTO TRAY SWITCH
ON
If two trays contain identical paper, the printer can
switch to an alternative source when the current tray
runs out in the middle of a print job.
TRAY SEQUENCE
DOWN
Determines tray sequence order when automatically
switching.
MP TRAY USAGE
DO NOT USE
If a document to be printed demands a paper size not
installed in the selected tray, the printer can
automatically feed from the multi purpose tray
instead. If this function is not enabled, the printer will
stop and request the correct size of paper to be
loaded.
MEDIA CHECK
ENABLE
Determines whether the printer check the size of
paper loaded matches that required for the document
sent to print.
RESOLUTION
600DPI
Sets the default resolution for printing (dots per inch).
1200DPI uses more memory and requires more time
to process, but prints at a higher quality.
TONER SAVE MODE
DISABLE
Use less toner 10pt characters print legibly, but 8 pt
characters do not.
ORIENTATION
PORTRAIT
Selects default page orientation between portrait
(tall) and landscape (wide). - (PCL, IBMPPR & EPSON
FX only)
LINES PER PAGE
64LINES
Sets the number of lines of text per page when raw
text is received from systems other than Windows.
The default for A4 portrait is 64, and for Letter is 60. -
(PCL only)
EDIT SIZE
CASSETTE SIZE
Sets the size of the printable page area to match the
size of paper in use. This is not the same as the
physical paper size, which is always slightly larger.
For dimensions of physical page sizes, see
section in this guide.
X SIZE
210MILLIMETER
Specifies paper width of Custom paper as a default
value.
Sets a paper size at right angles to the paper run
direction.
Y SIZE
297MILLIMETER
Specifies paper length of Custom paper as a default
value.
Sets a paper size in the same direction as the paper
run direction.
