Menu functions > 26
M
AINTENANCE
MENU
This menu provides access to various printer maintenance functions.
HUB LINK SETTING
AUTO NEGOTIATE
Sets full or half duplex for communication via a
network hub.When AUTO is set, negotiation is done
automatically.
FACTORY DEFAULTS
EXECUTE
Reloads the settings present when the unit was setup
by the manufacturer.
ITEM
DEFAULT
REMARKS
MENU RESET
EXECUTE
Resets menus to default settings.
SAVE MENU
EXECUTE
Saves the current menu settings. The last menu
executed is saved and the menu previously saved is
overwritten and erased.
When you press the ENTER button, the following
confirmation message is displayed.
ARE YOU SURE? YES/NO
If you select NO, the display returns to the previous
menu.
If you select YES, the current menu settings are
stored and the menu is exited.
POWER SAVE
ENABLE
Enables or disables automatic power save mode.
Delay before entering this mode is set in the SYS
CONFIG MENU.
SLEEP
ENABLE
Sets Enable/Disable of Sleep Mode.
USB HOST POWER
OFF
Sets power supply for USB-HOST of the whole
power save mode.
When Off, suppress power supply.When On, do
normal power supply.
PAPER BLACK SET
0
Used for small adjustments when you experience
faded print or light specks / streaking in
monochrome printing on white paper. Select a
higher value to reduce fading, or a lower value to
reduce specks or streaking in high density print
areas.
TRNSPR BLACK SET
0
As above but for mono printing on transparencies.
DARKNESS
0
Adjusts the darkness setting. Normal setting is 0.
SMR SETTING
0
Sets a correction value for uneven print quality, to
correct print variations caused by variations in
temperature and humidity or in print density/
frequency.
BG SETTING
0
Sets a correction value for dark-coloured paper
printing, to correct print variations caused by
variations in temperature and humidity or in print
density/frequency.
ITEM
DEFAULT
REMARKS
