Paper recommendations > 30
3.
Load paper long edge feed (LEF) (letter headed paper - face down and top edge
towards the right of the printer) (1) up to mark (a).
4.
Adjust the rear stopper, paper guides (2) and cassette tray roller (3) to the size and
orientation of paper being used.
5.
Close the paper tray gently.
If you have two trays and you are printing from the 1st (upper) tray, you can pull out
the 2nd (lower) tray during printing to reload it. However, if printing from the 2nd
(lower) tray, do not pull out the 1st (upper) tray. This will cause a paper jam.
If 3 trays are fitted this applies to trays 1 & 2 if printing from the 3rd (lower) tray.
To prevent paper jams:
>
Do not leave space between the paper and the guides and rear stopper.
>
Do not overfill the paper tray. Capacity depends on the type of paper stock.
>
Do not load damaged paper.
>
Do not load paper of different sizes or types at the same time.
>
Do not pull the paper tray out during printing (except as described above for the 2nd
tray).
CAUTION!
IMPORTANT: Set paper size dial (3) to the size and orientation of
paper being used (A4 LEF in the above example).
If the paper is oriented long-edge, the Long Edge Feed (LEF)
checkbox must be enabled in the printer driver.
If the paper is oriented short-edge, the Long Edge Feed checkbox
must be disabled in the printer driver.
If the driver setting doesn't match the paper orientation, the
printer will display an error message indicating that a mismatch
has occurred.
a
2
1
3
