2
Network Installation
Windows
®
Overview
Complete these steps to install your printer on a network:
1 Install the Ferrite Core
In order to reduce electromagnetic interference—”noise” that
interferes with TVs or other appliances—you must place the
enclosed ferrite core on the network cable connected to your
printer. Here is how to do it:
1. Disconnect the network cable from the printer, if necessary.
2. Loop the cable if necessary to keep the ferrite core in place.
3. Place the open core about 1 inch from the cable connector
on the printer end.
4. Press the two halves of the core together until they click
shut.
1 Install the Ferrite Core.
3 Assign an IP address
to the printer.
5 Install additional
network utilities.
4 Install the printer driver
and OKI LPR utility.
2 Connect the Ethernet
®
Interface.
6 Activate printer options.
IMPORTANT!
This safeguard is an FCC requirement.
Summary of Contents for C9600hdn
Page 19: ......
