1
1-2
Installing User Software on a Windows Computer
Setting up PostScript or PCL printing with
Windows 98/Me
To set up the Fiery as a PostScript or PCL printer, you must install the PostScript or
PCL printer driver for Windows 98/Me and, for PostScript, the corresponding printer
description file. You must also configure either a local connection for printing directly
or a network connection for printing over the network.
If you are printing using SMB (Server Message Block), you can connect to the Fiery
and install the printer drivers in a single procedure. For more information, see
up SMB printing with Windows 98/Me”
N
OTE
:
The procedures for setting up printing with the PostScript and PCL printer
drivers are similar. Either can, and should, be installed using the Installer program on
CD1 supplied with the C9800.
Installing the PostScript or PCL printer driver for
Windows 98/Me
The following procedure describes installing the printer driver from CD1. Subsequent
procedures describe configuring installable options and setting up the printer
connection.
N
OTE
:
It is strongly recommended that you use the supplied Drivers CD (CD1) to
install the printer drivers. This will automatically also install the OKI LPR utility,
which greatly simplifies network connection to the printer over a TCP/IP connection.
If you choose to use the standard Windows Add Printer Wizard, you will need to
install this utility from the CD afterwards if you require these features.
T
O
INSTALL
THE
P
OST
S
CRIPT
OR
PCL
PRINTER
DRIVER
FOR
W
INDOWS
98/M
E
1.
Insert CD1 into your CD drive and wait for the CD to autorun the setup program.
If the CD does not autorun navigate to the CD root directory and double-click the
setup.exe program to start the installer.
Summary of Contents for C9800hdn
