1
1-25
Setting up PostScript or PCL printing with Windows NT 4.0
Each connection (Hold, Print, or Direct) requires a new printer driver and printer
description file. To set up printing to a second or third print connection, repeat the
procedure
“To set up SMB printing on Windows NT 4.0”
on page 1-25. If you install
more than one printer, give each a descriptive name during printer driver installation,
such as
Aero-Print
or
Aero-Hold
, so you can easily identify printers.
N
OTE
:
To change printer defaults and configure installable options from Windows
NT 4.0, you must log on with the special log-in name, ‘efi_admin_efi’ (instead of
Administrator) and use the password specified in Fiery Setup. If you log on as a User,
you can install the printer driver through Point and Print, but you cannot modify
printer defaults and configure installable options.
B
EFORE
YOU
BEGIN
•
Configure the Fiery for SMB printing in Run Setup > Network Setup > Service
Setup > Windows Setup.
SMB printing is referred to as Windows Printing in Setup, on the Control Panel Map,
and on the Configuration page. For more information, see Chapter 2 of the
Configuration Guide
.
T
O
SET
UP
SMB
PRINTING
ON
W
INDOWS
NT 4.0
1.
Double-click Network Neighborhood.
Summary of Contents for C9800hdn
