ES9160 MFP / ES9170 MFP
© 2012 OKI DATA CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 102
6.17 Adjustment of the Finisher (MJ-1106)
6.17.1
Adjusting the Alignment Position
Perform this adjustment after replacing the Finisher control board or when the alignment position must
be changed for some reason.
Adjustment must be performed with 2 types of adjustment sheets for the A4 and LT series.
The adjustment value of A4 will be applied to the operation with A3, A4, A4-R, B4, B5, FOLIO, 8K, 16K.
The adjustment value of LT will be applied to the operation with LD, LG, LT, LT-R, COMP, 13 LG, 8.5”
SQ.
(1)
Turn OFF the power of the equipment.
(2)
Remove 2 screws and take off the board access cover.
(3)
Set the SW1 on the Finisher control board as shown in the figures below.
Adjusting for A4 size paper:
Turn ON pin 2 and 4.
Adjusting for LT size paper:
Turn ON pin 1, 2, and 4.
Fig.6-113
(4)
Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
The alignment plate moves to the A4 or LT size position and stops.
(It stops at the position of -5 steps from the center value of the adjustment range.)
ON
1
2
3
4
ON
1
2
3
4
Adjusting for A4 size paper
Adjusting for LT size paper
Board access cover
Summary of Contents for ES9160
