8.[Administration] Tab Page
[Setup] Item List 199
8 [Administration] Tab Page
Setting up Fax Destination
You can configure a network folder to store documents that are sent using the Fax driver with the Save as file option
enabled. Available only when the hard disk is installed.
Setting up Fax Folder
In the Fax Folder, you can specify in which network folder Fax documents are saved.
10
Retype Password
Enter the same password again for a confirmation.
Item name
Description
1
Do not allow any network folder to
be used as a destination
Select this to not allow any network folders to be used as Save as file destinations for Faxes
documents. When selected, users can only save an Fax document with the Save as file
option enabled to local storage.
2
Use Network Folder Destination
Select this to allow network folders to be used as Save as file destinations for Fax
documents. When selected, set the Fax Folder settings to specify which network folder to
use.
Item name
Description
1
Check box
Select the check box so that the popup prompts you to enter the network path or the server
name if you try to save the settings without it.
2
Protocol
Select the protocol for uploading an Fax document to a network folder.
y
SMB
— Select this to send an Fax document to the network folder using the SMB
protocol.
y
FTP
— Select this to send a file to the FTP server.
y
FTPS
— Select this to send a file to the FTP server using FTP over SSL.
y
NetWare IPX/SPX
— Select this to send a scanned file to the NetWare file server using
the IPX/SPX protocol.
y
NetWare TCP/IP
— Select this to send a scanned file to the NetWare file server using
the TCP/IP protocol.
3
Server Name
When you select [FTP] as the protocol, enter the FTP server name or IP address where an
Fax document will be sent. For example, to send an Fax document to the "ftp://192.168.1.1/
user/scanned" FTP folder in the FTP server, enter "192.168.1.1" in this box.
When you select [NetWare IPX/SPX] as the protocol, enter the NetWare file server name or
Tree/Context name (when NDS is available).
When you select [NetWare TCP/IP] as the protocol, enter the IP address of the NetWare file
server.
4
Port Number(Command)
Enter the port number to be used for controls if you select [FTP] as the protocol. Generally "-
" is entered for the control port. When "-" is entered, the default port number, that is set for
FTP Client by an administrator, will be used. If you do not know the default port number for
FTP Client, ask your administrator and change this option if you want to use another port
number.
Item name
Description
1
2
2
3
4
5
1
6
7
8
Summary of Contents for ES9455
