6 SETTING ITEMS
94 User Settings
EXPOSURE
Set the density at which the original is to be scanned.
TTI
Switch the TTI recording ON or OFF. To enable this feature, the Terminal ID must be registered to this equipment
in advance.
P.97 “Registering the terminal ID”
Setting this item may not be required since it may not be displayed on the screen (it depends on your country or
region).
RTI
Switch the RTI recording ON or OFF. To enable this feature, the Terminal ID must be registered to this equipment
in advance.
P.97 “Registering the terminal ID”
ECM
Switch the ECM (Error Correction Mode) communication ON or OFF.
ECM is an internationally standardized communication mode that automatically corrects errors that occur during
fax transmissions. With this setting option ON, even when the transmitted data have been affected by noise during
communication, this mode allows good communication without image distortion by automatically resending the part
that have been affected.
y
Both the sender and the receiver must have the ECM function to make ECM communication available.
y
When affected by noise during communication, communication time is slightly longer than usual. Even
when the ECM communication is used, an error may occur depending on the line status.
y
The ECM communication is not available for voice communication.
PREVIEW SETTING
Switch the preview setting ON or OFF.
This feature is available when the hard disk is installed in the equipment.
INITIAL PREVIEW TYPE
Set the preview type to be displayed as an initial
This feature is available when the hard disk is installed in the equipment.
SECURE RECEIVE FORCED SETTING
You can enable or disable the SECURE RECEIVE function.
This is available only when the WEEKLY SCHEDULE function is set.
ON: This enables the SECURE RECEIVE function.
It becomes disabled at the time set by WEEKLY SCHEDULE.
OFF: This disables the SECURE RECEIVE function.
y
It becomes enabled at the time set by WEEKLY SCHEDULE.
y
An administrator password is required.
AUTO:
This equipment automatically detects the contrast of the original, and scans it with the optimum
contrast.
MANUAL:
Press
or
to
set the desired contrast.
