7 TROUBLESHOOTING AND SPECIFICATIONS
108 Troubleshooting
Troubleshooting
Error codes
Below is a list of error codes that you might see in the lists or reports.
If you see an error code not listed here, retry the communication. If this error still occurs, contact your service
technician or service representative.
Error messages
Below is a list of error messages that might appear on the touch panel. When any message in the list appears on the touch
panel, press [RESET] on the control panel to clear it, and then take action suggested in the “Remedy” column.
Never attempt to repair, disassemble or modify the equipment by yourself.
You could cause a fire or get an electric shock. Always contact your service representative for maintenance or repair of
the internal parts of the equipment.
For error messages not listed above and their solutions, refer to the
Troubleshooting Guide
.
Error Code
Description
Remedy
0012
Original misfeed
Clear the misfed original.
0013
Door open
Firmly close the open door.
0020
Power interruption
Check the power interruption report.
0030
Reset
Transmission is cancelled.
(The transmission is terminated by the misfed printing paper during the
direct transmission.)
0033
Polling Error
Check polling options setup (Security code, etc.), and check if the polling
document exists.
0042
Memory full
Make sure that there is sufficient memory before making the call again.
0050
Line busy
Retry communications.
0053
Security mismatch in relay or mail
box transmission
Confirm the remote party’s security code, system password, and your
setup.
00B0 - 00E8
Communication Error
Retry communications.
Message
Cause
Remedy
Memory overflow
Memory overflowed when scanning documents to
the memory.
Either wait for memory to be cleared, or check
the jobs and delete reserved jobs to clear
memory.
Communication error
Communication error occurred during direct TX.
Retry communications.
Job reservation full
The number of reserved jobs exceeded the
maximum.
Either wait for job reservations to be completed,
or check the jobs and delete reserved jobs.
Job memory full
The total number of destinations for reserved jobs
exceeded the maximum.
Either wait for job reservations to be completed,
or check the jobs and delete reserved jobs.
Sorry not possible
On-hook or direct TX was attempted during
communications.
Wait for communications to end and retry
communications.
Not allowed now
Further polling transmission reservation was
attempted even though polling transmission was
already reserved.
Either wait for polling transmission jobs to be
completed, or check the jobs and delete reserved
jobs.
Too Many Tel # Digits
128 digits or more were registered for a chain dial
communication.
Confirm the number of digits dialed and register
the numbers again.
