- 11 -
5. DEFAULT SETTING
If Zebra command parameters, such as paper width, are not sent to the Oki Data printer, settings with key
operations are required to ensure the Oki Data printer operates properly.
In this case, enabling the Z-MODE on the printer allows parameter settings with key operations.
The set parameters are retrieved when the program of the Z-MODE is started.
An example of the operating procedure for LE840/LE850 is shown below.
Operation Example
Power OFF
(1) Power off state
[FEED] [PAUSE]
(2) While holding down the [FEED] and
[PAUSE] keys, turn on the printer power.
SYSTEM MODE VX. X
<1> DIAG.
<2> PARAMETER SET
<3> ADJUST SET
<4> TEST PRINT
(3) The system mode menu is displayed.
[DOWN] x 11
SYSTEM MODE VX. X
<10> RFID
<11> RTC
<12> Z-MODE
<13> USB MEMORY
(4) Press the [DOWN] key until the cursor stops
at <12>Z-MODE.
[ENTER]
(5) Press the [ENTER] key.
<12> Z-MODE
OFF
ON SETTING OFF
ON SETTING ON
(6) Z-MODE setting menu
Enable or disable the Z-MODE with the
[UP] or [DOWN] key.
[DOWN]
(7) Press the [DOWN] key.
<12> Z-MODE
OFF
ON SETTING OFF
ON SETTING ON
(8) Z-MODE is enabled but the BASIC system
mode program is not activated.
[DOWN]
(9) Press the [DOWN] key.
<12> Z-MODE
OFF
ON SETTING OFF
ON SETTING ON
(10) Z-MODE is enabled and the BASIC
system mode program is activated.
[ENTER]
(11) Press the [ENTER] key.
SET PARAMETER
(12) Z-MODE’s parameter setting menu is
displayed.
[PAUSE]
(13) Press the [PAUSE] key.
LABEL LENGTH
0105.0 mm
(14) Label length setting
Set a value using the [FEED] or
[RESTART] key. To move the cursor,
use the [PAUSE] key.
