- 136 -
8.97 ^MU SET UNITS OF MEASUREMENT
Format: ^MUa,b,c
a = dot/inch/mm
D : Dot
I : Inch
M : mm
Default: “dot/mm/inch” in the default setting file
When omitted: This command is ignored.
b = Format base in dpi
150, 200, 300
When omitted: This command is ignored.
c = Conversion dpi
300, 600
When omitted: This command is ignored.
*1 While the individual position and size vary depending on whether the ^MU/^JM command is placed
before or after ^FO/^FT/^LH/^LS/^LL/^PW or other command with Zebra, the position and the size
vary per label with Oki Data.
*2 Drawing running over in the horizontal direction is printed as it is with Oki Data. However, when
magnified, the portion running over the set width is not printed. In the case of Zebra, drawing
running over the set width is not printed. (If the drawing data before magnification is set to a value
exceeding the set width after magnification, the drawing data before magnification is printed without
being magnified horizontally.
*3 As with the case where the format base dpi is 200 and the conversion dpi is 300, if the conversion
result is 1.5 times the base, the result is ignored.
*4 The conversion dpi shall always exceed the format base dpi.
*5 In the case of Zebra, magnified printing is not performed for ^BD (UPS Maxicode) and ^BR (GS1
DataBar), it is performed with Oki Data.
*6 While the paper length is extended with magnification, if it exceeds 0355.6 mm (14 inches), the
magnification is disabled and same-size printing is performed.
