- 165 -
8.126 ^SX SET ZEBRANET ALERT
Format: ^SXa,b,c,d,e,f
a = Condition type
A : Paper out
B : Ribbon out
C : Print head over-temp
D ; Print head under-temp (unsupported)
E : Head open
F : Power supply over-temp (unsupported)
G : Ribbon-in warning (direct thermal mode) (unsupported)
H : Rewind full
I : Cut error
J : Printer paused
K : PQ job completed
L : Label ready (unsupported)
M : Head element out
P : Power on (unsupported)
Q : Clean print head (unsupported)
R : Media low (unsupported)
S : Ribbon low (unsupported)
T ; Replace head (unsupported)
U : Battery low (unsupported)
V : RFID error (reserve)
W : All errors
* : All errors
When omitted or an unsupported parameter is set, this command is ignored.
b = Destination
A : Serial port (RS-232C)
B : Parallel port (unsupported)
C : E-mail address (unsupported)
D : TCP/IP
E : UDP/IP
F : SNMP trap (unsupported)
When omitted or an unsupported parameter is set, this command is ignored.
c = Enable condition set alert
Y : Yes
N : No
When omitted: Y
d = Enable condition clear alert
Y : Yes
N : No
When omitted: N
