- 169 -
8.129 ~WC PRINT CONFIGURATION LABEL
Format: ~WC
*1 While Zebra prints a configuration label after data is segmented by specified label length, Oki Data
prints diagnostic label without segmentation.
*2 In the case of Zebra, if "Bitmap clear: No” (^MCN) is selected, printing is performed without clearing
the drawing areas. In the case of Oki Data, the drawing area is always cleared.
*3 The sensor type, the print mode, and the tag rotation are forcibly set to ‘No sensor,’ ‘Tear-off,’ and
‘Normal,’ respectively, for printing labels. When the Z-MODE is in the cutter mode, cutting is
performed after self-diagnostic printing but not after maintenance counter printing. For the print
speed and ribbon presence settings, the values set before this command is received are used for
printing labels.
*4 In the case of Oki Data, since diagnostic printing is performed with 'No sensor” forcibly selected,
the following operation is performed after printing:
If a sensor is selected and calibration operation is not selected:
One-label feed and feed to the print start position are performed.
If a sensor is selected and calibration operation is selected:
Calibration is performed.
*5 If ~WC is placed in ^XA to ^XZ and data to be printed such as ^FD is not placed before ~WC,
diagnostic printing is performed when the command is received. If data to be printed is placed
before ~WC, diagnostic printing is performed after print processing is made with ^XZ.
*6 Even if 'Reprint' is selected for the FEED key function, re-print cannot be performed by pressing
down the FEED key after printing a piece of blank paper following self-diagnostic printing with this
command. However, a depression of the FEED key after printing the maintenance counter and
the parameter settings causes a re-print.
*7 When performing self-diagnostic printing with this command, the following items that affect the
printing operation from that on are not checked and “-” is printed:
Self-diagnosis items which cause LE840/LE850 series to print "-"
