- 34 -
*8 While Font 0 is scalable, as the loaded fonts are different from those for Zebra, the font, size, space
between characters, etc. may differ.
*9 In the case of Zebra, the font selected in ^CF command is used when the name of nonexistent font
is selected. However, in the case of Oki Data, the font to be used follows the font conversion table
in ZDEFAULT.TXT.
*10 When OKI outline font is selected, the print image of character data using ^SN, ^SF, ^FV, or ^FC
command collapses from the second page on.
8.2 ^A@ USE FONT NAME TO CALL FONT
Format: ^A@o,h,w,d:o.x
o = Font rotation
N : 0°
R : 90°
I : 180°
B : 270°
When omitted: Value of ^FW
* The point of origin differs depending on the coordinate designated in ^FT and ^FO.
h = Character height (in dots)
Font 0:
10 to 32000 dots
* Through correction, the final size shall be in the range from 1 mm to 150 mm.
Other than font 0:
If the character height exceeds 9.5 times the font standard height, it is corrected to 9.5 times.
When omitted: Calculated from the width based on the ratio.
If both height and width are omitted, the height is calculated from the value in ^CF.
w = Character width (in dots)
Font 0:
10 to 32000 dots
* Through correction, the final size shall be in the range from 1 mm to 150 mm.
Other than font 0:
If the character width exceeds 9.5 times the font standard width, it is corrected to 9.5 times.
When omitted: Calculated from the height based on the ratio.
If both height and width are omitted, the width is calculated from the value in ^CF.
d = Drive
R: RAM
E: On-board Flash ROM
B: USB memory
A: USB memory
When omitted: R:
o = File name
When omitted: UNKNOWN
x = Extension
When omitted: FNT
*1 When Font 0 is selected, the print image collapses if there exists other print data in the printing
area.
*2 The referable font names (“d:o.x”) are limited to those in the “Font Conversion Table” or those in
the max. of seven downloaded TTFs.
A font name is valid only when all of the drive, file name, and extension are perfectly
