51
Status LEDs for the Head Check Setting Mode
Head checking can be applied to one of two areas: the
normal print area
and the
barcode print area
. To specify
the area subjected to a head check, follow the settings in the
table below (cover must be left open):
You can check the current setting with a test printout as
described in “Performing a Test Print” on page 38.
When setting the Head Check options, the STATUS LED blinks
green, and turns into a steady green signal upon completion
of setting. Turn off the printer
ONLY
when the STATUS LED is
a steady green light.
Status LEDs for the Online Command
Compatibility Mode
The printer can be set for compatibility with SBPL commands
or with the older MB200 commands.
You can check the current setting with a test printout as
described in “Performing a Test Print” on page 38.
H.Check
setting
DSW-1
DSW-2
DSW-3
DSW-4
Other keys
Normal Print
Area
OFF
ON
OFF
ON
hold down
PRINT button
Disable H.
Check
OFF
ON
OFF
ON
hold down
FEED button
Barcode Print
Area
ON
OFF
OFF
ON
hold down
PRINT button
Disable H.
Check
ON
OFF
OFF
ON
hold down
FEED button
Compatibility
DSW-1
DSW-2
DSW-3
DSW-4 Other keys
LP440-
compatible
online
commands
ON
ON
ON
ON
hold down
PRINT button
SBPL online
commands
ON
ON
ON
ON
hold down
FEED button
Summary of Contents for LP441s
