Windows Utilities
- 124 -
For Windows PS Drivers
1
Launch the printer properties screen.
Reference
2
Select the [
Device Settings
] tab.
3
Click on [
Get installed options
automatically
] and then click on
[
Setup
].
4
Click [
OK
].
Uninstall the Utility
1
Click on [
Start
], and then select
[
Control Panel
]>[
Add or Remove
Programs
].
2
Select [
OKI Network Extension
] and
click on [
Remove
].
3
Follow the instructions on the screen and
complete the uninstallation.
TELNET
You can configure each type of setting with a
Telnet command.
Note
Telnet access to the machine settings is turned off in the
initial settings.
In order to use Telnet commands, set [
Telnet
] to
[
Active
], either on the webpage or on the machine control
panel.
For Windows 7/Windows Vista/Windows Server 2008 R2/
Windows Server 2008, Telnet commands are inactive in
the initial settings.
In order to use Telnet commands, select [
Start
] >
[
Control Panel
] > [
Programs
] > [
Programs and
Features
] > [
Turn Windows features on or off
]. Set
[
Telnet Client
] to active in the displayed dialog box.
Memo
For the next procedure, the following environment will be
used as an example. The details may differ depending on
the OS you are using.
- OS: Windows 7
- IP Address: 192.168.0.2
- MAC Address: 00:80:87:84:9C:9B
1
Click on [
Start
] and select [
All
Programs
]>[
Accessories
]>
[
Command Prompt
].
2
Following "(Driver Password): /Users/
Username>" enter "ping (Space)
machine IP Address".<
Press the
Enter
> key and check that access is
enabled.
E.g.: "C:/Users/WINDOWS > ping 192.168.0.2"
3
Following "telnet (Space)", enter the IP
address of the machine and press the
<
Enter
> key, in order to access the
machine through Telnet.
E.g.: "C:/Users/WINDOWS>telnet 192.168.0.2"
4
After "login:" enter "root" and press the
<
Enter
>.
5
If a prompt is displayed, enter your
password following "Password" and press
the <
Enter
> key.
Enter E.g: "password: 849C9B".
Memo
The default "root" password is the last 6
alphanumerical digits of the machine's MAC address.
6
If a menu command is displayed, enter
the menu number you would like to
change, and press the <
Enter
> key.
7
Change the settings as required.
8
Save settings and log out of the
machine.
