Changing Network Settings From the Web Page
- 155 -
Network S
et
tings
8
You need to set the mail server to allow the machine to
send an e-mail. For details on the mail server setting, refer
to your network administrator.
If you use Internet Explorer 7, be sure to configure the
settings below before you send a test mail. In the browser,
select [
Tools
] > [
Internet Options
], then click [
Custom
Level
] on the [
Security
] tab. Then select [
Enable
] in
[
Allow websites to prompt for information using
scripted windows
].
1
Access the machine's web page and log
in as the administrator.
2
Select [
Admin Setup
].
3
Select [
Network Manager
]>[
]>
[
Send Settings
].
4
Follow the on-screen instructions to
specify detailed settings.
5
Select [
Set detail of the SMTP
Protocol
].
6
If necessary, you can configure
[
Security Settings
], [
Configure
attached information
], and [
Others
].
7
Click [
Send
].
The network card reboots to enable the new
settings.
Regular Alert
1
Access the machine's web page and log
in as the administrator.
2
Select [
Admin Setup
].
3
Select [
Network Manager
]>[
]>
[
Alert Settings
].
4
Enter an e-mail address to receive the
alerts.
5
Click [
Setting
] for the specified address.
[
Copy
] is useful when you want to apply the alert
conditions to another address..
6
Follow the on-screen instructions to
specify detailed settings.
7
Click [
OK
].
8
Click [
View a summary of current
configuration
] to check the current
settings, and then click [
X
] to close the
window.
You can also check the current settings of up to
two addresses on the main window. Select the
desired addresses to check from the list box.
9
Click [
Send
].
The network card reboots to enable the new
settings.
Memo
If there is no error specified, the alert e-mail is not sent.
Alert At Time of Error Occurrence
1
Perform steps 1 to 6 in
When an error or warning is selected to require
notification, a window will display to specify the
time between error occurrence and sending the
alert.
2
Specify the time to sending of an error
alert and then click [
OK
].
If you specify a longer time, you are only notified
of persisting errors.
3
Click [
OK
].
4
Click [
View a summary of current
configuration
] to check the current
settings, and then click [
X
] to close the
window.
You can also check the current settings of up to
two addresses on the main window. Select the
desired addresses to check from the list box.
5
Click [
Send
].
The network card reboots to enable the new
settings.
Using SNMPv3
When you use the SNMP manager that supports
SNMPv3, the management of the machine is
encrypted by SNMP.
1
Access the machine's web page and log
in as the administrator.
2
Select [
Admin Setup
].
3
Select [
Network Manager
]>[
SNMP
]>
[
Setting
].
4
Follow the on-screen instructions to
specify detailed settings.
5
Click [
Send
].
The network card reboots to enable the new
settings.
Memo
Your machine has an SNMP agent. You can confirm and
change the machine settings by a commercially available
SNMP agent. For the MIB of the machine, refer to the
software DVD-ROM and check the "README" file in the
[
Misc
] > [
MIB
] folder.
