- 71 -
Config
uring
at t
h
e Oper
ator P
anel
6
6. Configuring at the Operator Panel
This chapter explains how to configure the equipment settings from the <
SETTING
> key on the
operator panel.
Changing the Equipment Settings
This section explains the basic procedure to change the equipment settings.
Reference
For details on the menu structure of the equipment settings, refer to
.
Memo
An item which cannot be re-set is indicated as [---].
Admin Setup or Easy Setup
To enter the [
Admin Setup
] menu or the [
Easy
Setup
] menu, an administrator password is
necessary.
Memo
The default password is "aaaaaa".
1
Press the <
SETTING
> key to open the
equipment setting menu.
2
Press the to select [
Admin Setup
] or
[
Easy Setup
] and then press .
3
Enter the administrator password.
4
Select [
Enter
] and then press .
5
Press the to select the setup menu on
which you want to change a setting and
then press .
6
Change the setting and then press
For [
Easy Setup
], repeat step 6 until the
message indicating the setting completion is
displayed.
7
For [
Admin Setup
], press the until
the top screen appears.
For [
Easy Setup
], press the to
complete the setup.
Memo
If you want to cancel the setup of [
Easy Setup
], press
<
RESET/LOG OUT
> key.
Other Menus
1
Press the <
SETTING
> key to open the
equipment setting menu.
2
Press the to select the setup menu on
which you want to change a setting and
then press .
3
Change the setting and then press .
4
Press the until the top screen appears.
OK
OK
OK
OK
OK
