- 6 -
Power Supply Precautions
WARNING
There is a risk of getting an electric shock
and/or causing fire.
z
Be sure to cut off the power supply when attaching or removing the power supply plug or the earth wire.
z
Be sure to connect an earth wire to the grounding terminal of exclusive use.
z
Please do not connect with the ground of a water pipe, a gas pipe, and a telephone wire, or lightning rod
without fail.
z
Make sure to connect with the ground terminal before connecting the power cord to the power supply plug.
z
Be sure to perform extraction and insertion of the power cord with a power supply plug.
z
Insert the power supply plug into the wall socket securely.
z
Do not touch the power cord, or machine, if your hands are wet.
z
Install the power cord in a location where it will not be stepped on, and do not place objects on the power cord.
z
Do not twist, bind, or knot the power cord.
z
Please do not use a damaged power cord.
z
Do not carry out foot wiring.
z
Use the attached power cord and insert it directory with the ground terminal. Do not use power cords intended
for other products with this machine.
z
Do not use an extension cord. When use is unavoidable, use a cord rated higher than 15A.
z
Use of an extended cord may cause AC voltage decrease and interfere with normal operation.
z
During operating, do not shut off the power supply or pull out the power supply plug.
z
When not in use for consecutive holidays or longterm travel, pull out the power cord.
z
Do not use the attached power cord for other products.
Power Supply Conditions
Observe the following power supply conditions.
Current:
100 - 127 VAC
(Range 90 - 140 VAC)
220 - 240 VAC
(Range 198 - 264 VAC)
Power
frequency: 50/60 Hz ± 2 %
Note
z
If the power supply is unstable, use a voltage regulator.
z
The maximum power consumption of the conveyor is 60 W. Check that there is sufficient voltage capacity.
z
Operations cannot be assured if using an uninterruptible power supply (UPS) or inverter. Do not use an uninterruptible power
supply or inverter.
