UNIX 111
UNIX
Overview
The OkiLAN 7300e supports many protocols such as LPD, FTP, TELNET,
SNMP and IPP, and works within the UNIX environment.
To use the network card within the UNIX environment, the following
steps are required:
Configuration
Network Interface card setting
The first step in installing the network card under UNIX is to set up the
IP address, Subnet Mask and Gateway. This section explains one way
to set them up from a UNIX workstation.
>
The network addresses used in this manual are shown as
examples only. Network addresses used in your installation
must be generated for your own network.
>
Login as [root] to change the configuration of the OkiLAN 7300e.
By default, there is no root password.
>
If an incorrect IP address, Subnet Mask or Gateway is entered,
the network may go down or other damage may occur. Check the
address with your network manager.
The following explanation uses Sun Solaris 2.8 (Solaris 8) as an
example. The actual commands may differ between versions of UNIX,
so refer to the workstation manuals for more information.
1.
Logging as root to the workstation
>
If you do not have superuser rights, the network manger should
conduct the configuration.
2.
If the OkiLAN 7300e does not have an IP addresses already
assigned, use the
arp
command to set a temporary IP address.
Example: for IP address 192.68.20.127 and network card address
00:80:92:01:00:D2
Summary of Contents for OkiLAN 7300e
