122
OKIPOS 425D
|
7. Using the Unitool Printer Driver
7.1 Setting Slip Paper in the Paper Tray
This section describes the method to set Slip paper in the input bin. With this printer, the position of the Paper Guide can be
adjusted sideways, enabling you to change the paper setting position. If you use this printer driver, however, follow the
procedure below when determining the right/left margins for paper and the position to set the Slip paper. Some examples and
cautionary notes for use are provided below.
In normal operation, push the Paper Guide for Slip toward the right against the Slip Tray when using this printer driver. (Slide
the Paper Guide toward the left as needed, to change the printing area on the paper. For more details, refer to “7.1.1 Using
Registered Paper Icons.”)
The first 25.4 mm (1.0") along the right side of the paper is not printable; therefore, set the right margin at 27.94 mm (1.1") or
more in normal operation. This printing area is outlined below.
O425_107.jpg
1
Printing area
2
Left Margin 2.54mm [0.1 inch] or more
3
Right Margin 27.94mm [1.1 inch] or more
4
Printing disabled area 25.4mm [1.0 inch]
5
Printable Maximum Width 160.02mm [6.3 inch]
The maximum printable width per line with Slip paper is 160.02mm(6.3").
The following two types of paper are usable for Slip.
- Paper sizes that are registered as an Icon in Paper Properties/Paper Tab/Paper Size.
- Custom Size
As each paper size is used differently, refer to the various paper setups described in 7.4 and after.
