- 133 -
(6)
Remove any paper left inside the each removed cutter unit with tweezers.
(7)
Clean the cutter blade.
Cleaning the stationary blade of the cutter unit (upper)
Press the cleaning stick soaked with the wiping solution (free of water) against the
straight blade (stationary blade) to remove the glue adhering to the blade.
Cleaning the rotary blade of the cutter unit (lower)
While turning the gear by hand and turning the spiral blade to the front, move the
cleaning stick soaked with the wiping solution (free of water) left and right while pressing
it against the blade on the spiral to remove the adhered glue.
Spiral blade (Rotary blade)
Gear
• Check that there is no glue left on the cutter blade. If glue remains, clean the cutter blade again in the same way.
•
Check that there is no cloth/lint left on the cutter blade or in the cutter unit. If it remains, wipe it off again
with a cleaning stick.
• After cleaning, wipe it dry with a cleaning stick.
• A cutter blade is equipped for cutting roll paper inside the cutter unit. Do not push in touch the cutter blade
with your hand. Otherwise injury may be caused.
• Cleaning sticks are recommended for cleaning. Please contact your retailer to purchase them.
Summary of Contents for PRO330S
