- 125 -
Cleaning the LED head
Clean the LED head when blurred or white streaks appear on the printing result or when the
text is blurred.
Clean the LED head when vertical white lines appear on the printing result or when edges of
the text are blurred. If the LED head is dirty, a paper jam may occur.
• Do not use methyl alcohol or thinner. Otherwise the LED head may be damaged.
•
Do not expose the image drum to direct sunlight or strong light (approx. 1,500 lux or above). To leave it even
under indoor lighting for more than 5 minutes, or to leave the top cover open, be careful to cover it with a black
cloth or newspaper to avoid direct light.
1
Take off your watch or bracelet.
2
Put your finger inside the recess on the top of the machine, and pull the
lever up.
3
Open the top cover until it stops.
Summary of Contents for PRO330S
