DDR-04 / DDR-08-1U / DDR-16-1U User’s Manual
R201302-V08
26
Step2: click Add button, a dialog box will pop-up as Fig 4-34:
Fig 4-34 add-general
①
General: Input user name, password; select user type: normal and advance, input the MAC address of the PC;
click OK button, this user will be added into the user list box; click Exit button to exit the current interface.
Note: when the default value of binding PC MAC address is 0, the user is not bind with the specify
computer; the, the user can log in DVR on the binding computer after set the specific binding MAC
address.
②
Authority:
a) Admin: Admin have full control of DVR. DVR could have only one admin account.
b) Advance: Besides ”firmware upgrade”, ”reset factory default”, ”shut down” and ”change other user’s
password”, advance account could control DVR like an admin account.
c) Normal: Normal account can only do “live view”, “playback”, “search”, “backup”, “log off”, “view DVR
information”, and “change his own password”.
4.7 P.T.Z configuration
P.T.Z configuration includes two submenus: serial port and advance
①
Serial port
Step1: enter into system configuration
P.T.Z configuration
serial port; refer to Fig 4-36:
Fig 4-36 P.T.Z
configuration-serial port
Step2: tick off Enable, setup the value of address, baud rate and protocol according to the settings of the speed
dome.
Step3: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit
current interface.
