DDR-04 / DDR-08-1U / DDR-16-1U User’s Manual
R201302-V08
33
Step2: click Refresh button to refresh the disk information of the list box; set the property of the disk then click Apply
button to save the setting
Step3: checked a hard disk, click Format button to star format.
Note: all recorded files in the hard disk will be lost after formatted.
6.1.8 Upgrade
At present, it only supports USB update. Get the firmware from your vendor when there is a new firmware version,
and make sure it is corresponding with the DVR. User can check the USB information in Disk manager.
6.1.9 Logoff
Click Log off icon, a log off dialogue box will popup, click OK button, the device will log off. If user wants to log in
again, click icon to enter into user name and password to relogin.
6.1.10 Shut
Down
Note: DVR going to power off
7.1 Accessing DVR
If making remote view, the DVR must connect with LAN or internet. Then enable network server in the unit. Please refer
to 4.6 Network Configuration.
This unit supports IE browser, without any client software installed. It supports Win 7, XP and Vista.
7.1.1 On LAN
Step1: Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in both the DVR and router. Enter
Menu—Information—Network, and user can check the network configuration of DVR.
Step2: Enter Video to set network video parameters like resolution, frame rate etc.
Step3: Open IE browser on a computer on the same LAN. Input the IP address of the DVR in IE address blank and
enter.
Step4: IE will download ActiveX automatically. Then a window pops up and asks for user name and password.
Step5: Input name and password correctly, and enter. It will show the picture as below.
Fig 7-1 View with IE browser
Notice:
If HTTP port is not 80, other number instead, need add the port number after IP address. For example, set
HTTP port as 82, need input IP address like http://192.168.0.25:82.
User name and password here are the same with that used on the DVR. The default is admin and 123456.
7.1.2 On WAN
There are two ways that the DVR is connected to internet.
1. Connect the DVR to internet through a router or virtual server.
Step1: Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in both the DVR and router.
Step2: Enter Video to set network video parameters like resolution, frame rate etc.
Step3: Forward IP address and port number in Virtual Server setup of the router or virtual server. Close firewall.
Notice
:
Forwarding block may be different in different routers and server, please check your router manual.
7. Remote Surveillance
