4
Basic Setup
Enter the OSD main menu and setup some basic configuration of the DVR. The basic configuration
can be set via either the DVR or DVR
Remote
, the remote software.
Enter OSD Main Menu:
•
Press
MENU
to enter the OSD main menu.
•
Enter username and password. The default username and password is
admin
and
1234
.
•
Press
MENU
again to quickly input the default username “
admin
”.
•
It is strongly suggested to change the password to prevent unauthorized access.
Date / Time Setting:
Follow steps below to setup date/time before the recording starts.
•
Select
<
Date/Time
> in System Setup menu.
•
Select the date and time using
LEFT/RIGHT
keys; then adjust the value using
UP/DOWN
keys.
•
The new date and time settings take effect after the changes are confirmed.
Language Setting:
If users wish to change language of the DVR system, follow the steps below.
•
Select
<
Language
> in System Setup menu and press
ENTER
.
•
Press
the
UP/DOWN
keys to select the desired language.
Network Setup
Configure the LAN setup for the DVR to properly function with Ethernet connection.
•
From OSD main menu, select <
System Setup
>
Æ
<
Network Setup
>, set the <
LAN Select
>
item to <
LAN
> or <
PPPoE
> according to the network application, and enter <
LAN Setup
>.
•
For DHCP user, set the DHCP to <
ON
>. The IP address, Netmask, Gateway and DNS settings
are retrieved from network servers. DHCP is dynamic that the settings change from time to time.
•
For Non-DHCP user, set the DHCP to <
OFF
>. Enter an IP address, Netmask, Gateway, and
DNS settings. Please obtain the information from the network service provider.
•
To change the IP address, Netmask, Gateway and DNS value, press
UP/DOWN
keys to move
the cursor to the item. Use
LEFT/RIGHT
keys to access each section of the value and press
ENTER, then change the value using
UP/DOWN
keys.
•
PPPoE users must set the <
PPPoE Account
>, <
PPPoE Password
> and <
PPPoE Max Idle
>
as well.
•
When the settings are complete, press
ENTER
to confirm and save the settings; or
ESC
to
abort.
