52 / 62
53 / 62
The Compass Calibration failed.
You moved too fast or too slowly.
The probe was pivoted while calibrating.
There are too many ferromagnetic interferences
in the area (e.g. power lines).
Retry calibration: Press the trigger and start rotating as slowly as described in
.
Retry calibration: Hold the detector horizontally during the complete calibration process.
Press the trigger and start rotating.
Retry calibration in a place where there are less magnetic interferences. Make sure there
are no power lines above or a electric fences near you. The Compass may not work indoors.
3D Ground Scan does not start. Instead, I see the
following screen:
GPS is trying to locate your position.
Make sure there are no interfering barriers like a roof or dense trees above the smart-
phone to allow GPS tracking. GPS tracking does not work indoors.
You should switch off GPS in the Settings menu to disable GPS.
Thermo Scan does not start. Instead, I see the
following screen:
GPS is trying to locate your position.
Make sure there are no interfering barriers like a roof or dense trees above the smart-
phone to allow GPS tracking. GPS tracking does not work indoors.
You should switch off GPS in the Settings menu to disable GPS.
My scan data look unusual and/or seem to be
incorrect.
The sensor range has been exceeded.
The internal batteries are too low.
The detector is too close to other electric
or magnetic devices, or in atmospheric
conditions such as lightning prevail.
Make sure you hold and move the probe in the correct orientation
according to the recommendations of the selected operating mode.
Charge the detector batteries – see
4.1 Charge Internal Batteries on page 13
Keep at least 160 ft (50 m) distance to magnetic fields, electric motors, speakers, phones,
keys, and jewelry. Avoid using the detector during thunderstorms – see
.
NOTES
