Operating modes
29
Should the signal become unstable, stop moving the control unit and hold it vertical and still. Then push the
trigger button so that the unit can perform a ground balance. Once the unit has re-balanced itself, you can
continue on with your scanning. This task can be performed as often as you like or as is needed.
Use the “Magnetometer” function to look for smaller objects like nails, screws or other ferromagnetic items
which have a tendency to give off undesirable results in other scans, like those created by using the function
“3D Ground Scan”. Not only will you be able to find the smaller objects that lie on the surface but of course
you will be able to located larger ferromagnetic objects that are buried deeper in the ground. The more of the
smaller targets that are absent in a scan, the easier it is to locate items that are deeper.
If your desired target is a ferromagnetic item in the ground, then you can use the “Magnetometer” as a pin
pointing tool and localize its exact position from the surface. For ferromagnetic items this is a quick and easy
way to locate and pin point sub-surface targets.
When you are finished with the “Magnetometer” mode, simply tap on the arrow
to end the function and
return back to the main menu on the smartphone.
OKM GmbH
Summary of Contents for Fusion
