De-ashing system settings
119
The burner fan runs after the minimum delay time has elapsed even until the flue
gas temperature is lower than the boiler tempe the set temperature value:
e.g: Boiler temperature = 76°C + 32°C = 108°C Switch off temperature.
The flue gas fan runs after the minimum delay time until the flue gas temperature is
lower than the boiler tempe the set temperature value:
e.g: Boiler temperature = 76°C + 12°C = 88°C Switch off temperature.
Note:
Display only if flue gas sensor is connected.
The burner fan runs after the minimum delay time until the combustion chamber
temperature is lower than the boiler tempe the set temperature value:
e.g: Boiler temperature = 76°C + 250°C = 326°C Switch off temperature.
The flue gas fan runs after the minimum delay time until the combustion chamber
temperature is lower than the boiler tempe the set temperature value:
e.g: Boiler temperature = 76°C +150°C = 226°C Switch off temperature.
Back to the menu
Pellematic
.
113
3..114
4..7
7 D
De
e--a
as
sh
hiin
ng
g s
sy
ys
stte
em
m s
se
ettttiin
ng
gs
s
The de-ashing system is fully automatic. A dedicated motor in the sub-assembly of the de-ashing system dri-
ves the de-ashing auger. Its function is controlled and tested by the boiler controller.
The motor in the sub-assembly of the de-ashing system drives the de-ashing auger and the turnstile agitator
arm. The agitator arm conveys the ash to the de-ashing auger. The de-ashing auger conveys the ash from the
ash chamber into the ash box.
When the ashbox is full then the alarm text
"Ash"
appears on the display of the control unit. If you do not
empty the ash box, the completes a futher 3 de-ashing sequences before failing. The control unit then dis-
plays the alarm text
"Ash box full"
. The heating system switches off. The heating system switches back on
again automatically after the ash box has been emptied.
For pellets with a very high ash content, it is necessary to extend the duration of the de-ashing process and
possibly also extend the time interval between de-ashing processes.
Operating Manual PELLEMATIC® PE(S)(K)(B) 10 — 56
Summary of Contents for PE 08
