TOTAL POS SOLUTION COMPANY
OKPOS
Manual
Service
ZED POS
1. Configuration of Main Board
2. Configuration of Major I/O Ports
Appendix
1. Stand
2. Cable Cover
3. Rear Cover
4. Main Press
5. Internal System Configuration
6. Storage Replacement
Assembly / Disassembly
1. System On/Off
2. Touch Screen
3. Disk back-up and Recovery
4. Dual monitor (Optional)
5. Magnetic Stripe Reader (Optional)
System Installation
and Usage
1. Preview
2. Features and Specifications
3. Parts Description
System Introduction
Use it by touching the screen
3
Click
‘
Multiple Monitors
’
After checking
‘
Multiple Monitors
support
’,
click
‘
Map Touch Screens
’
Touch main screen
Press
‘
S
’
on the keyboard
(if use dual-Touch,
touch dual-monitor screen)
Click
‘
Configure
’
Click
‘
Advanced Calibration
’
Touch as a point target
Turn-on the system and boot it using OS
After double-clicking touch-setting icon on
‘
Screen
’
mode, set it up following the below procedure
2
1
This is how to calibrate the touch points when using the system with dual monitor.
Expansion Setup for Touch-coordinate
